Abstract
The printability of paper in flexography is largely dependent on the topographical characteristics of the substrate. Topography imaging instruments make it possible to obtain three-dimensional scans of paper surfaces that can be further used to calculate valuable quality parameters. The primary aim of the work described in this thesis has been to identify and isolate structural properties of the paper surface which significantly influence the ink distribution during printing and limit the subsequently attainable print quality.OptiTopo is an optical imaging technique which provides precise and fast topographic scans of both printed and unprinted paper surfaces. The potential and limitations of the technique have been evaluated. The optical requirements on the substrate for an accurate and precise topographic scan were determined. Detail-rendering was substantially improved using a custom-designed restoring filter, and a new enhanced spatial resolution range was established. A combination of further algorithm improvements made it possible also to obtain reflectance-factor-calibrated intensity images of scanned printed surfaces.Serious deficiencies affecting the quality of flexographic prints may appear in the form of local unprinted areas (UCA) in a full-tone print, generally caused by incomplete ink transfer. An algorithm detecting and quantifying local uncovered area was developed, tested and successfully integrated with the OptiTopo instrument. A UCA occurrence frequency distribution, indicating the percentage of the uncovered area at a certain topographical elevation, was calculated for different prints. The topographic characteristics of the uncovered areas clearly indicate that surface depressions are the primary cause of uncovered areas in flexographic printing.Four different predictive models based on topography thresholding were proposed and tested using two independent quality judgement criteria. These quality indices took into account both the amount and location of the predictions. A deeper understanding of the topographical features governing UCA occurrence was established with a proposed ink bridging effect. The total risk of non-ink-covered areas in flexography printing due to topographical features was estimated.The overall influence of paper topography on the flexography printability of full-tone areas was studied and its importance for the ink distribution assessed. The impacts of printing plate hardness, printing pressure, anilox cylinder volume and substrate roughness were quantified. Two typical flexography patterns were identified and their origin discussed: sub-millimetre elongated structures and millimetre-scale blotches.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.