Abstract

Numerical predictions of a series of shake-table tests are presented in this paper in order to examine the accuracy of a 3-D effective stress analysis in predicting the behavior of piles subjected to liquefaction-induced ground flow. For a rigorous assessment of the analysis, “Class B” predictions are reported in which numerical and constitutive model parameters were set before the event, and the target motion was used as an input motion in the analysis. Modeling of the stress–strain behavior of sand, identification of the initial stress state and critical numerical parameters in the 3-D seismic analysis of the soil–pile system are discussed in detail. Combined effects of kinematic loads due to large lateral ground movement and inertial loads on pile behavior are examined through a series of tests using different shaking direction, excitation amplitude and mass of the footing (load from the superstructure). By and large, very good agreement was obtained between the predicted and measured peak responses of the pile foundation, whereas the analysis underestimated the displacements of the sheet-pile wall and was less accurate in predicting the residual deformation of the foundation piles. Reasons for these discrepancies and limitations of the analysis method are discussed.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.