Abstract
In this article, the variation of hardness in cross-section of X52 microalloyed steel joints before and after post-weld heat treatment and also the relationship of hardness with ultimate tensile strength, yield strength and microstructure have been investigated. For this purpose, the specimens were prepared in two conditions of as welded and post-weld heat treated, and the hardness maps of their cross-section were provided. Then, some equations were suggested to correlate the obtained hardness with the grain size and tensile and yield strengths. The equations made it possible to predict tensile and yield strengths with high accuracy. According to the results, the maximum hardness and strength belong to the weld junction. Normalisation of the joints at 950°C reduced significantly the hardness difference (and also the strength difference) in various joint areas and homogenised the microstructure considerably. The grain size distribution was also modelled acceptably for the post-weld heat treated joint, and the grain size map was obtained.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
