Abstract
In Part I of this two-part paper, the orifice equations were solved for the case of externally induced (EI) ingress, where the effects of rotational speed are negligible. In Part II, the equations are solved, analytically and numerically, for combined ingress (CI), where the effects of both rotational speed and external flow are significant. For the CI case, the orifice model requires the calculation of three empirical constants, including Cd,e,RI and Cd,e,EI, the discharge coefficients for rotationally induced (RI) and EI ingress. For the analytical solutions, the external distribution of pressure is approximated by a linear saw-tooth model; for the numerical solutions, a fit to the measured pressures is used. It is shown that although the values of the empirical constants depend on the shape of the pressure distribution used in the model, the theoretical variation of Cw,min (the minimum nondimensional sealing flow rate needed to prevent ingress) depends principally on the magnitude of the peak-to-trough pressure difference in the external annulus. The solutions of the orifice model for Cw,min are compared with published measurements, which were made over a wide range of rotational speeds and external flow rates. As predicted by the model, the experimental values of Cw,min could be collapsed onto a single curve, which connects the asymptotes for RI and EI ingress at the respective smaller and larger external flow rates. At the smaller flow rates, the experimental data exhibit a minimum value of Cw,min, which undershoots the RI asymptote. Using an empirical correlation for Cd,e, the model is able to predict this undershoot, albeit smaller in magnitude than the one exhibited by the experimental data. The limit of the EI asymptote is quantified, and it is suggested how the orifice model could be used to extrapolate the effectiveness data obtained from an experimental rig to engine-operating conditions.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.