Abstract
In this research, the effects of torque tightening on the fatigue strength of 2024-T3 aluminium alloy double lap bolted joints have been studied via experimental and multiaxial fatigue analysis. To do so, three sets of the specimens were prepared and each subjected to different levels of torque i.e. 1, 2.5 and 5Nm and then fatigue tests were carried out at various cyclic longitudinal load levels. A non-linear finite element ANSYS code was used to obtain stress and strain distribution in the joint plates due to torque tightening of bolt and longitudinal applied loads. Fatigue lives of the specimens were estimated with six different multiaxial fatigue criteria by means of local stress and strain distribution obtained from finite element analysis. Multiaxial fatigue analysis and experimental results revealed that the fatigue life of double lap bolted joints were improved by increasing the clamping force due to compressive stresses which appeared around the hole.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.