Abstract
A common problem with most polymers is their crude oil-based production and hence their negative environmental impact. Therefore, changing to bio-based and biodegradable polymers like polylactide acide (PLA) as promising candidate could be a reasonable alternative. PLA is characterized by very good mechanical properties, but rather poor surface properties for functional applications. A material-friendly and frequently used technique for surface modification is the deposition of hydrogenated amorphous carbon (a-C:H) by plasma-enhanced chemical vapor deposition (PECVD) using acetylene. Here, a 50 μm thick PLA foil was coated with a-C:H layers of various thickness (50 nm up to 500 nm). Surface topography is analyzed with scanning electron microscopy (SEM), chemical composition by diffuse reflectance infrared Fourier transform (DRIFT), and wettability by contact angle. Additionally, layers were investigated by X-ray photoelectron spectroscopy (XPS) and near edge X-ray absorption fine structure (NEXAFS) at the synchrotron facility BESSYII resulting in thickness dependent changes of the sp2-/sp3-binding ratio. As the layer thickness increases, the topography also changes, showing internal stress-induced cord buckling and delamination phenomena for the carbon layers. Present results provide an improved understanding for the coating of the organic biopolymer PLA with the predominantly inorganic a-C:H via in situ growth.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
