Prediction of 3D grinding temperature field based on meshless method considering infinite element

Abstract

A three-dimensional numerical model to calculate the grinding temperature field distribution is presented. The finite block method, which is developed from meshless method, is used to deal with the stationary and the transient heat conduction problems in this paper. The influences of workpiece feed velocity, cooling coefficient, and the depth of cut on temperature distribution are considered. The model with temperature-dependent thermal conductivity and specific heat is presented. The Lagrange partial differential matrix from the heat transfer governing equation is obtained by using Lagrange series and mapping technique. The grinding wheel-workpiece contact area is assumed as a moving distributed square heat source. The Laplace transformation method and Durbin’s inverse technique are employed in the transient heat conduction analysis. The results of the developed model are compared with others’ finite element method solutions and analytical solutions where a good agreement is demonstrated. And the finite block method was proved a better convergence and accuracy than finite element method by comparing the ABAQUS results. In addition, the three-dimensional infinite element is introduced to perform the thermal analysis, and there is a great of advantages in the simulation of large boundary problems.