Abstract
This study evaluates the distortion in an SLM-printed Ti-6Al-4V control arm plate of a double-wishbone suspension linkage. Temperature gradients are a common observation in selective laser melting (SLM). The development of residual stresses can lead to performance-based concerns due to the distortions emerging in part. Despite these shortcomings, SLM has often been employed in manufacturing high-end structural components under its ability to produce complex geometries. A thermomechanical simulation predicts the residual stresses developed in part and the distortions generated by those stresses. The simulation model is validated by reconstructing the printed part using computerized tomography (CT) and aligning it with the original design. The results reveal a close correlation between the predicted and the observed distortion, with the thickness of features and the location of support structures having a significant impact on postprint parts. Additionally, the study on build orientation helps understand the distribution of residual stresses and their redistribution after removing support structures.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
