Predicting Adsorption Isotherms of Low-Volatile Compounds by Temperature Programmed Desorption: Iodine on Carbon

Abstract

Equilibrium adsorption isotherms for low-volatile compounds are extremely difficult to measure. A simple technique using temperature programmed desorption (TPD) is proposed. It is demonstrated that the two parameters needed for constructing the Langmuir isotherm can be derived with data from the TPD technique alone. Thus, the Langmuir isotherms of iodine on AX-21 super-activated carbon were obtained with this technique. A series of TPD experiments for samples with different initial loadings of iodine were carried out by varying the heating rates which resulted in different peak desorption temperatures. The peak desorption temperature decreased as the initial loading was increased because of the re-adsorption effect. The Langmuir constant was derived from kinetic theory with the activation energy for desorption obtained from the experiment. The activation energy for desorption was 12.3 kcal/mol. The Langmuir constants determined by this technique were in comparable order of magnitude to the reported values for iodine on activated carbon. The saturation capacity of AX-21 for iodine could also be determined from the TPD data obtained from samples with different initial loadings. The estimated saturation capacity from the TPD experiment was 2.96 g I(2)/g AX-21, which was close to the experimentally measured saturation capacity of 3.25 g I(2)/g AX-21 for the same system.