Abstract
Demands of glass Fresnel lens is increasing in solar panel in order to increase power efficiency. Glass lens is usually molded by glass molding method with tungsten carbide molds. In this study, large Fresnel lens molds made of tungsten carbide are tested to be ground by simultaneous 2-axis (Y, Z) controlled grinding method. The resinoid bonded diamond wheel was trued with a rare metal truer to improve the sharpness of the wheel edge. In the grinding test of the tungsten carbide mold, a form accuracy of less than 0.8 μm P-V and surface roughness of 18 nm Rz were obtained, and it is clarified that the proposed grinding method is useful for the Fresnel grinding.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.