Abstract
In reverse engineering applications, there is a problem of precise alignment from measured data to a CAD model. This paper presents a new method where the measurement points can be precisely aligned with its corresponding CAD model. Initially, the measured data is aligned approximately through a least-square method with the minimum distance principle. Based on this initial alignment result, the precise alignment is completed through the Differential Evolution (DE) algorithm and the Simplex method. The experimental results show that the alignment algorithm proposed in this paper possesses an accuracy of 0.055m and spending less processing time than the genetic algorithm. Therefore, the proposed method is effective for the measured data alignment to the original surface model. DOI: http://dx.doi.org/10.11591/telkomnika.v11i3.2310
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: TELKOMNIKA Indonesian Journal of Electrical Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
