Abstract
Passivation of semiconductor surfaces is crucial to reduce carrier recombination losses and thereby enhance the device performance of solar cells and other semiconductor devices. Thin-film stacks of phosphorus oxide (PO x ) and aluminum oxide (Al 2 O 3 ) have recently been shown to provide excellent passivation of semiconductor surfaces, including crystalline silicon and indium phosphide, and can also be highly interesting for passivation of other semiconductor materials such as Ge and III-V semiconductors. On silicon, the excellent passivation is attributed to the combination of a high positive fixed charge and a very low interface defect density. On InP nanowires, application of the PO x /Al 2 O 3 stacks improves charge carrier lifetime threefold as compared to unpassivated nanowires. In this work, we review and summarize recent results obtained on PO x /Al 2 O 3 stacks for semiconductor surface passivation. Several topics are discussed, including the passivation performance on various semiconductor surfaces, the processing of the PO x and Al 2 O 3 layers, the role of the capping layer, and aspects related to device integration. The PO x /Al 2 O 3 stacks feature some unique properties, including an unusually high positive fixed charge density, a low interface defect density, and can be prepared over a wide deposition temperature range. These unique properties arise in part from the mixing process that occurs between the PO x and Al 2 O 3 layers, which upon post-deposition annealing leads to the formation of AlPO 4 . The surface passivation provided by PO x /Al 2 O 3 stacks is highly stable and the stack can be used to conformally coat high-aspect-ratio structures such as nanowires, showing their promise for use in semiconductor devices. • PO x /Al 2 O 3 stacks provide excellent surface passivation on Si and InP. • PO x /Al 2 O 3 has a unique high positive fixed charge density (10 12 -10 13 cm −2 ) on Si. • PO x /Al 2 O 3 has low interface defect density down to 10 10 -10 11 eV −1 cm −2 on Si. • The Al 2 O 3 layer mixes with PO x during deposition, leading to AlPO 4 upon annealing. • The surface passivation quality provided by PO x /Al 2 O 3 is stable for over 1000 days.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.