Power and power density analyzes of an endoreversible modified variable-temperature reservoir Brayton cycle with isothermal heat addition

Abstract

The mistakes in recent literatures are analyzed, and a new model for an endoreversible closed modified Brayton cycle with isothermal heat addition coupled to variable-temperature reservoirs is established using finite-time thermodynamics in this paper. The range of isothermal heat addition modification is determined, and the analytical formulae of the dimensionless power output, thermal efficiency and dimensionless power density of the cycle are derived. The effects of the cycle parameters on the global performances of power output and power density and the performances at maximum power design and maximum power density are analyzed by numerical calculations. The results show that there exist optimal compressor pressure ratios, respectively, which lead to maximum dimensionless power output and maximum dimensionless power density, that the optimal compressor pressure ratio and the thermal efficiency at maximum power design are always smaller than the corresponding ones at maximum power density design, and that dimensionless power output and maximum specific volume at maximum power design are always bigger than the corresponding ones at maximum power density design. The results imply that the power density design possesses the advantages such as smaller equipment volume and higher thermal efficiency at the cost of disadvantages such as bigger compressor pressure ratio and power output loss. Maximizing the power density gives a compromise between power and the size of the engine. The calculations also show that an endoreversible closed modified Brayton cycle with isothermal heat addition cannot work at the maximum thermal efficiency design point.