Abstract
Sendust Fe-Si-Al ternary alloys have high saturation flux density, low coercive force and high resistivity. Moreover, they are strong against wear, so efforts have been devoted to make use of these alloys as the video-tape-recorder head materials. These alloys are too hard and brittle to be made into thin sheets by rolling and punching. We tried to make Sendust sheets by powder rolling process. Two kinds of powders, atomized or mechanically crushed, were used. Si and Al contents in the former are approximately twice as those in Sendust standard composition, and we added pure iron powders in order to prepare Sendust alloys sheets by powder rolling process more easily.We excuted many experiments to get the optimum condition of powder rolling and sintering. Electrical and mechanical properties of typical samples are given as follows ;μ m=5600; BH c=0.45 Oersted; B r=5600 Gauss; B 10=9700 Gauss; ρ=100 μΩ-cm; Hv=443.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Journal of the Japan Society of Powder and Powder Metallurgy
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
