Abstract
The potential utilization of burned wood in the manufacture of medium density fiberboard (MDF) was investigated. For this aim, the MDF panels were made of various mixtures of burned pine wood (Pinus sylvestris L.), unburned beech (Fagus orientalis L.) and oak (Ouercus robur L.) woods under commercial conditions in an MDF company. The mixture ratio of the unburned beech and oak woods to the burned pine wood were 50/50 wt%. The mixing ratios of burned wood chips with unburned wood chips were 0:100, 25:75, 50:50, 75:25 and 100:0, %, respectively. A commercial urea–formaldehyde resin was used as a binder. The physical properties measured in the investigation included density and thickness swelling, while the mechanical properties examined were bending strength, modulus elasticity, internal bond, screw holding ability perpendicular to the plane of panel, and janka hardness perpendicular to the plane of the panel. Surface roughness and color of the panels were also measured. The results indicated that all the panels met the mechanical properties of general-purpose MDF requirements of EN 622-5. The surface roughness of the MDF panels containing burned wood decreased with increasing burned wood content but remained higher than the control panels. The dimensional stability of the MDF panels decreased with the incorporation of burned wood fibers as compared with the control MDF panels.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.