Potential environmental pollution hazards by coal based power plant at Jhansi (UP) India

Abstract

Coal, a fossil fuel, is the largest source of energy for the generation of electricity in India. In order to study the potential environmental hazards by coal based power plants, particulate matters were collected using Stack Monitoring Kit and gaseous pollutants by Automatic Flue Gas Analyzer. The morphological and chemical properties, mineralogical composition and particle size distributions have been determined by SEM–EDX, XRD and CILAS. The data revealed the presence of particulate matters, SO2, NOx in the range of 236–315, 162–238, 173–222 mg/Nm3 respectively. The emission of CO2 was in the range of 43,004–60,115 Nm3/h with an average of 52,830 Nm3/h. Among the elements, Fe > Mn > Al > Zn > B > Ni > Cr > Cu were present in substantially higher proportion than Pb > Mo > Cd > Se > As > Hg. It was found that most of the elements were concentrated on fly ash surface rather than coal, bottom ash and pond ash. This variation may be attributed to the fineness of fly ash particles with large surface ratio to mass. Mineralogical studies of coal and fly ash by X-ray diffraction revealed the presence of mullite, quartz, cristobalite and maghemite. Presence of mullite and quartz found in fly ash indicate the conversion of complex minerals to mullite and quartz at high temperature. Transfer Coefficient was calculated to determine the ratio of the enrichment of trace elements in fly or bottom ash with respect to coal and pond ash.