Potential Dermal Exposure to Flonicamid and Risk Assessment of Applicators During Treatment in Apple Orchards

Abstract

Exposure and risk assessments of flonicamid for applicators were performed in apple orchards in Korea. Fifteen experiments were done with two experienced applicators under typical field conditions using a speed sprayer. In this study, cotton gloves, socks, masks, and dermal patches were used to monitor potential dermal exposure to flonicamid, and personal air samplers with XAD-2 resin and glass fiber filter were used to monitor potential inhalation exposure. The analytical methods were validated for the limit of detection, limit of quantitation, reproducibility, linearity of the calibration curve, and recovery of flonicamid from various exposure matrices. The results were encouraging and acceptable for an exposure study. The applicability of XAD-2 resin was evaluated via a trapping efficiency and breakthrough test. During the mixing/loading, the average total dermal exposure was 22.6 μg of flonicamid, corresponding to 4.5×10−5% of the prepared amount. For the spraying, the potential dermal exposure was 9.32 mg, and the ratio to applied amount was 1.9 × 10−2%. The primary exposed body parts were the thigh (2.90 mg), upper arm (1.75 mg), and lower leg (1.66 mg). By comparison, absorbable quantity of exposure was small, only 1.62 μg (3.2×10−6%). The margin of safety (MOS) were calculated for risk assessment, in all sets of trials, MOS > 1, indicating the exposure level of flonicamid was considered to be safe in apple orchards. Although this was a limited study, it provided a good estimate of flonicamid exposure for orchard applicators.