Potassium Ion-Selective Electrodes with BME-44 Ionophores Covalently Attached to Condensation-Cured Silicone Membranes.

Abstract

For ion-selective electrodes (ISEs) to be employed in wearable and implantable applications, the ion-selective membrane components should be biocompatible, and leaching of components, such as plasticizer or ionophore, out of the sensing membrane should be inhibited. To achieve this, we employed a plasticizer-free silicone as the membrane matrix and synthesized as the ionophore a derivative of the bis-crown ether based potassium ionophore BME-44, incorporating a triethoxysilyl functional group that covalently attaches to condensation-cured silicones during the curing process. Soxhlet extraction of these membranes with dichloromethane shows that up to 96% of the ionophore is attached to the silicone membrane during curing. We found that the covalently attachable BME-44 derivative can inadvertently adsorb onto high surface area carbon solid contacts before attaching to the silicone matrix if the curing of the silicone is performed in the presence of the high surface area carbon, resulting in depletion of ionophore from the membrane and yielding solid-contact ISEs with poor selectivity. In contrast, we observed Nernstian responses to K+ in plasticizer-free silicone-based K+ ISMs with either mobile BME-44 or the covalently attachable BME-44 derivative when the membranes were prepared on octane-thiol coated gold electrodes, where ionophore adsorption does not occur to a noticeable extent. As compared with ISMs doped with the mobile BME-44, ISMs prepared with the covalently attachable BME-44 derivative have better selectivity for K+ vs Na+ ( values of -3.54 and <- 4.05 for mobile and covalently attachable BME-44, respectively) and lower resistance. This can be explained by a more homogeneous incorporation of the covalently attachable BME-44 derivative into the silicone matrix than is the case for the mobile BME-44.