Post-failure behavior of 2-ply laminated glass plates with different interlayers

Abstract

Modern design codes, such as the new Eurocode on the design of structural glass components, consider the prediction of the post-failure behavior of these elements of paramount importance for a proper and safe design. In this view, an experimental investigation is presented in the paper, on the mechanical response of undamaged and damaged 2-ply Laminated Glass (LG) under quasi-static loads, with different interlayers, namely polyvinyl butyral (PVB), SentryGlas (SG) and a plasticized version of PVB, Saflex DG41 (DG41). Firstly, undamaged specimens (UDLG) were tested in simply supported configuration (configuration 0) with a vertical load in the middle increased up to the failure of the bottom glass ply. damaged LG specimens (PDLG) were then tested into two different configurations: configuration I, with broken ply below (bottom ply) and configuration II, with broken ply above (top ply). All the presented tests were performed under displacement control. For both configurations, the interlayers influence on the post-breakage behavior was discussed. It is underlined that the global response of the two configurations was completely different: configuration II, which was characterized by a deformed shape opposite to the load direction, showed a good residual stiffness and reached high failure loads. On the contrary, in configuration I, the response was characterized by a low stiffness and load carrying capacity. In addition, also the influence of different glass types was discussed, focusing attention on tempered and toughened glass. The results showed that the contribution of the fractured layer cannot be disregarded in the evaluation of the global stiffness of a PDLG and its contribution is strictly related to the interlayer and glass typologies.