Abstract
This retrospective study was conducted to analyze the clinical results in 26 patients with lesions at the craniocervical junction that had been treated by occipitocervical reconstruction using pedicle screws in the cervical spine and occipitocervical rod systems. To evaluate the effectiveness of pedicle screw fixation in occipitocervical reconstructive surgery and to introduce surgical techniques. Many methods of occipitocervical reconstruction have been reported, but there have been no reports of occipitocervical reconstruction using pedicle screws and occipitocervical rod systems for reduction and fixation. Twenty-six patients with lesions at the craniocervical junction underwent reconstructive surgery using pedicle screws in the cervical spine and occipitocervical rod systems. The occipitocervical lesions were atlantoaxial subluxation associated with basilar invagination, which was caused by rheumatoid arthritis in 19 patients and other disorders in 7. The lowest cervical vertebra of fusion in 16 patients was C2, and the remaining 10 patients underwent fusion downward from C3 to C7. Flexion deformity of the occipitoatlantoaxial complex was corrected by application of extensional force, and upward migration of the odontoid process was reduced by application of combined force of extension and distraction between the occiput and the cervical pedicle screws. Solid fusion was achieved in all patients except two with metastatic vertebral tumors who did not receive bone graft for fusion. Correction of malalignment at the craniocervical junction was adequate, and postoperative magnetic resonance imaging showed improvement of anterior compression of the medulla oblongata. There were no neurovascular complications of cervical pedicle screws. Occipitocervical reconstruction by the combination of cervical pedicle screws and occipitocervical rod systems provided the high fusion rate and sufficient correction of malalignment in the occipitoatlantoaxial region. Results of this study showed the effectiveness of cervical pedicle screw as a fixation anchor for occipitocervical reconstruction.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.