Post-treatment of thermal spray coatings on magnesium

Abstract

Magnesium alloys have a beneficial combination of high strength to weight ratio, good machinability and high recycling potential. Despite this, the application of magnesium still is behind that of other constructive materials mainly due to low wear and corrosion resistance. For more demanding applications, a large amount of surface treatment methods are developed to overcome this problem. Thermal spraying is an efficient and flexible method of coating deposition and is widely used for protection of different materials against corrosion and wear. Nevertheless, the bonding of thermal spray coatings on magnesium alloys is not sufficient, so the following post-treatment processes are needed. One of such possibilities is high energy beam treatment of thermally sprayed coatings. During the heat treatment of magnesium substrates with coating the remelting of coating and a thin surface layer of substrate occurs. Depending on the combination of applied coating system and treatment method, different processes can be realised in modified layers: the alloying of magnesium substrate with other elements to improve corrosion properties, redistribution of hard particles from composite coating and new phases formation during the processing to improve the wear resistance of magnesium alloys. In the present work some examples concerning the laser and electron beam treatment of aluminium based composite coatings as well as infra red irradiation of zinc based coatings are described. Coatings are deposited on magnesium substrates (AM20, AZ31, AZ91) by arc spraying with Zn, ZnAl4 and ZnAl15 solid wires and cored wires in aluminium core with powder filling containing different hard particles, such as boron, silicon and tungsten carbide or titanium oxide. Remelting of thermal spray coatings is carried out by means of continuous irradiation of СО 2-laser in nitrogen or argon atmosphere, electron beam in vacuum and focused tungsten halogen lamp line heater in atmosphere. Microstructure of sprayed coatings as well as that of modified surface layers is investigated by metallographic methods. Corrosion properties are estimated by electrochemical measurements. Abrasion wear resistance of the modified layers is determined by scratch test, corundum grinding disk test and Rubber wheel test. It is shown that all methods applied for processing of thermal spray coatings lead to formation of modified surface layers in magnesium substrate with improved wear and corrosion properties. Different mechanisms of microstructure formation such as redistribution of chemical composition of composite coating components, partial remelting of hard phase particles, and new phases formation are discussed. Electrochemical behaviour of modified surface layers is mostly improved due to alloying, homogenization of element distribution and strong decrease of as-sprayed coating porosity. Abrasion wear resistance of processed magnesium substrates strongly depends on the microstructure and usually is 5 to 20 times higher compared with base material.