Abstract
Internal combustion engines are increasingly regulated in regard to efficiency and environmental impact, which requires advanced optimization strategies of engine components. The contact between the top ring and the cylinder liner is critical to the efficiency of an internal combustion engine. As shown in a previous study, an amorphous carbon coating can greatly improve the friction properties of piston rings. This work expands on these results by fabricating laser‐interference‐induced microchannels on the coating perpendicular to the direction of movement with a mean depth of 0.97 and 3.13 μm spatial period to further optimize the tribology. Fired single‐cylinder engine measurements of the microtextured rings show a significant reduction in mean piston assembly friction of 5% for operation points that are relevant for urban transportation and up to 10% for specific operation points. Subsequent multibody elastohydrodynamic simulations prove that measured friction changes result from the compression ring microtexture. In particular, the microtexture increases the hydrodynamic pressure, reduces hydrodynamic losses, and leads to 20% lowered compression ring losses for an entire combustion cycle of the investigated operation point. In the future, such tribological concepts can be deployed in internal combustion engines that are powered by sustainable hydrogen or methanol.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.