Porous Morphology of High Grafting Density Mixed Polyelectrolyte Brushes Grown from a Y-Inimer Coating.

Abstract

Mixed A/B polyelectrolyte (PE) brushes of opposite charges are grown from a Y-shaped initiator-bearing coating to facilitate intimate mixing of the A and B polyelectrolytes in a 1:1 grafting ratio. The design of the Y-shaped inimer includes both ATRP and NMP initiators attached to a common Y-junction. A copolymer of a Y-shaped inimer with glycidyl methacrylate is cross-linked to the substrate resulting in a stable ultrathin coating decorated with Y-shaped initiators. Weak PE A/B mixed brushes based on poly(methacrylic acid)/poly(2-vinylpyridine) (PMAA/P2VP) with a high grafting density of ∼1 chain/nm2 are grown by surface-initiated ATRP and NMP, respectively. Detailed morphological characterization of the PMAA/P2VP brushes in response to pH changes reveals a nanoporous morphology under conditions that maximize complex coacervate formation between oppositely charged brushes. The charge ratio between the A and B brushes is varied via the composition of the brushes to further study the morphology evolution. The effect of intimate contact between the A and B brushes on the morphology is probed by comparing with a mixed A/B PE system with random fluctuations in grafting composition. A quantitative and qualitative study of the pore evolution with pH as well as charge composition is presented using a combination of atomic force microscopy, water contact angle measurement, and image analysis using Gwyddion software. These studies demonstrate that the porous morphology is enhanced and most uniform when the brushes are grown from the Y-inimer, indicating that a 1:1 grafting ratio and intimate contact between A and B brushes are essential.