Porous heat exchange tube with ultra-thin dense skin layer via NIPS for AGMD process

Abstract

In this paper, a kind of poly(vinylidene fluoride) (PVDF) porous heat exchange tube (HET) was prepared via non-solvent induced phase separation (NIPS) method. This porous HET possessed an ultra-thin dense skin layer of 2 μm. Since the thermal conductivity of water is higher than that of PVDF, filling the pores with water can significantly improve the heat performance of the porous HET. A full plastic double-pipe air gap membrane distillation (AGMD) module was fabricated with the porous HETs and PVDF hollow fiber membranes. In the AGMD process, the wetting treatment can make the membrane distillation flux (J) and the gained output ratio (GOR) increased by 30%. During the long-term stability test, the maximum conductivity of distillate water was only 17.2 μS/cm. The experimental results demonstrated that the porous HET can be applied for the AGMD process to treat high saline brine, and the ultra-thin dense layer can prevent the leakage of saltwater.