Abstract
The humidity sensing performance and mechanism of surface acoustic wave (SAW) sensors with cellulose acetate (CA) films were studied. The porous microstructure and strong interaction with water molecules of CA films are favorable for its attraction to water molecules, thus greatly improving the humidity sensing performance of SAW sensors, which have been verified by scanning electron microscopy (SEM), N2 adsorption, and Raman characterizations. The SAW sensors coated with 4 wt% CA films show a sensitivity of 9.46 kHz/%RH, linear response, and good stability in the humidity range of 20%–90%, along with a short response time (21 s) and recovery time (14 s). In contrast, extremely low responses were observed in the sensing tests of the same sensors to other gases (CO, H2S, NH3, SO2, CH4, and NO). Both variations of mass and conductivity of sensing films can cause the frequency shift. The conductivity change of the CA film provides only a small part of the frequency response. Conversely, the adsorption of water molecules increases the mass of the CA film, which results in the dramatic and fast frequency response of the sensor to humidity variation.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
