Abstract
Laser cladding of homogeneous coating onto ZL205A substrate by using a high-power diode laser was investigated in order to repair casting defects of ZL205A aluminum alloy. Single and multi-layer laser cladding was carried out to optimize laser process parameters. Pores on the cross-sections of the laser-clad coatings were chain-like and distributing along the bottom of the molten pool. Lower powder feed rate and relatively higher laser power were helpful in eliminating porosity defects, and pores larger than 100μm in diameter were successfully eliminated by optimizing laser and material parameters. The microstructure of the laser-clad coating was columnar and columnar dendrite structures with reticular Al2Cu phase precipitating in the grain boundary. The microhardness of the laser-clad coating (about 75HV) was significantly lower than that of the substrate (about 152HV), and could be improved to about 134HV after suitable solution treatment afterward artificial aging treatment, which was helpful to the restoration of coatings' mechanical properties.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
