Porogen Concentration Effect on the Pore Structure and Properties Evolution of Polymer Monolith Based on Oligocarbonate Dimethacrylate OCM-2.

Abstract

Porous polymer monolith materials of 2-mm thickness were obtained by visible light-induced radical polymerization of oligocarbonate dimethacrylate (OCM-2) in the presence of 1-butanol (10 to 70 wt %) as a porogenic additive. The pore characteristics and morphology of polymers were studied by mercury intrusion porosimetry and scanning electron microscopy. Monolithic polymers with both open and closed pores up to 100 nm in size are formed when the alcohol content in the initial composition is up to 20 wt %. The pore structure in such materials is a system of holes in the bulk of the polymer (hole-type pores). Open interconnected pores with a specific volume up to 2.22 cm3/g and modal pore size up to 10 microns are formed in the volume of the polymer with 1-butanol content of more than 30 wt %. Such porous monoliths are a structure of covalently bonded polymer globules (interparticle-type pores). The free space between the globules represents a system of open interconnected pores. In the transition region of 1-butanol concentrations (from 20 to 30 wt %), areas with both structures and intermediate frameworks, as well as honeycomb structures of polymer globules connected by bridges, are fixed on the polymer surface. It was found that the transition from one type of pore system to another is accompanied by a sharp change in the strength characteristics of the polymer. Approximation of experimental data using the sigmoid function made it possible to determine the concentration of the porogenic agent in the vicinity of which the percolation threshold is observed.