Abstract
Admicellar polymerization has been used for the preparation of an electrically conductive polypyrrole coating on latex particles. An anionic surfactant, sodium dodecyl sulfate (SDS), was adsorbed onto natural rubber (NR) latex particles to form the surfactant bilayers after adjusting the pH below the point of zero charge of the latex surface. Adsorption of SDS and pyrrole adsolubilization were determined as a function of pyrrole and sodium chloride concentrations. Pyrrole caused a decrease in SDS adsorption at equilibrium. Sodium chloride increased the surfactant adsorption and the pyrrole adsolubilization. Thermogravimetric results showed the presence of polypyrrole. The conductivity of the polypyrrole-coated NR latex film prepared by admicellar polymerization without salt was the lowest; however, with salt addition, the conductivity of the film improved significantly. The oxidative polymerization technique resulted in a relatively higher conductivity than oxidative admicellar polymerization.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
