Abstract
A new cost-effective setup for silicon bulk micromachining is presented which makes use of a polymeric protective coating, ProTEK® B2 coating, instead of a conventional hardmask. Different concentrations of KOH and bath conditions (pure, with surfactant, with stirrer, with both surfactant and stirrer) have been considered. ProTEK® B2 coating exhibits good adhesion to Si substrates, no degradation, etching rates and surface roughness comparable to literature data, and etching times greater than 180 min without damaging front side microstructures. Microcantilevers have also been fabricated using two different process flows in order to demonstrate the suitability of such a protective coating in microelectromechanical system (MEMS) technology.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.