Abstract
A rapid and cost-effective lithographic method, polymer blend lithography (PBL), is reported to produce patterned self-assembled monolayers (SAM) on solid substrates featuring two or three different chemical functionalities. For the pattern generation we use the phase separation of two immiscible polymers in a blend solution during a spin-coating process. By controlling the spin-coating parameters and conditions, including the ambient atmosphere (humidity), the molar mass of the polystyrene (PS) and poly(methyl methacrylate) (PMMA), and the mass ratio between the two polymers in the blend solution, the formation of a purely lateral morphology (PS islands standing on the substrate while isolated in the PMMA matrix) can be reproducibly induced. Either of the formed phases (PS or PMMA) can be selectively dissolved afterwards, and the remaining phase can be used as a lift-off mask for the formation of a nanopatterned functional silane monolayer. This “monolayer copy” of the polymer phase morphology has a topographic contrast of about 1.3 nm. A demonstration of tuning of the PS island diameter is given by changing the molar mass of PS. Moreover, polymer blend lithography can provide the possibility of fabricating a surface with three different chemical components: This is demonstrated by inducing breath figures (evaporated condensed entity) at higher humidity during the spin-coating process. Here we demonstrate the formation of a lateral pattern consisting of regions covered with 1H,1H,2H,2H-perfluorodecyltrichlorosilane (FDTS) and (3-aminopropyl)triethoxysilane (APTES), and at the same time featuring regions of bare SiOx. The patterning process could be applied even on meter-sized substrates with various functional SAM molecules, making this process suitable for the rapid preparation of quasi two-dimensional nanopatterned functional substrates, e.g., for the template-controlled growth of ZnO nanostructures [1].
Highlights
Self-assembled monolayers (SAMs) are well-known and have been intensively studied for many years, partly because of their interesting properties and partly because of interesting perspectives for potential applications as functional, ultrathin coatings [2,3,4,5]
Patterning of self-assembled monolayers on the nanometer scale is performed by sequential lithographic techniques that are well-established in the literature
The polymer-blend solution is prepared with PS and poly(methyl methacrylate) (PMMA) dissolved in methyl ethyl ketone (MEK)
Summary
Self-assembled monolayers (SAMs) are well-known and have been intensively studied for many years, partly because of their interesting properties and partly because of interesting perspectives for potential applications as functional, ultrathin coatings [2,3,4,5]. Polymer phase separation in thin films can be obtained by methods such as spin coating [31] and Langmuir–Schaefer deposition [45]. There is no direct way to use the resulting polymer blend film as a lithographic mask, because the formed structure contains both lateral and layered phase separations [49,50,51]. We are aiming for a lateral polymer phase morphology that can be completely removed by a selective solvent to make the substrate available for well-defined chemical surface modification.
Sign-in/Register to view highlights & summary Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
