Polyether-segmented nylon hemodialysis membrane. VI. Effect of polyether segment on morphology and surface structure of membrane

Abstract

Amorphous nylon, poly(iminoisophthaloyliminomethylene-1,3-cyclohexylenemethylene) (NyBI) and poly(ethylene oxide) (PEO)-segmented NyBI (PEO–NyBI) membranes were prepared by a phase-inversion method using water/dimethyl sulfoxide (DMSO) mixtures as coagulants. The influence of the PEO segment and coagulant compositions on the morphology of the membranes was investigated. The cloud-point curves in the polymer/DMSO/water ternary system showed that PEO–NyBI and NyBI had the same coagulation processes, that is, instantaneous liquid–liquid phase separation occurred, resulting in a fingerlike structure in the cross section of the membranes. The membrane morphologies observed under a scanning electron microscope (SEM) agreed with the prediction. The PEO segment had little or no effect on the membrane morphologies which were prepared in the coagulants with a low DMSO concentration, and it promoted the change of the phase-separation style from the instantaneous to the delayed one in the case of the DMSO-rich coagulant. The PEO segment, however, significantly influenced the ultrafiltration rate. Additionally, the relationship between the surface composition of the PEO–NyBI membrane and the coagulation condition was also investigated by use of electron spectroscopy for chemical analysis (ESCA) and static secondary ion mass spectrometry (SSIMS). A small enrichment of the PEO segment at the top surface of the membranes was observed with the increase of the DMSO concentration in the coagulant. © 1998 John Wiley & Sons, Inc. J Appl Polym Sci 69: 1645–1659, 1998