Abstract
In this study flax fabrics were treated with polyethylene imine (PEI) and afterwards, in combination with carbon fabrics, integrated into epoxy resin via vacuum infusion process. The influence of the 2 stacking sequences of the fabrics and 2 PEI concentrations were evaluated with regard to the mass fractions of the composite components and mechanical properties of the manufactured composites, namely, flexural and interlaminar shear properties. The results showed that the effect of the surface treatment is dependent on the stacking sequence. Namely, increase of the PEI concentration resulted in a corresponding increase of the mass fraction of the polymer matrix in the case of interchanging arrangement of flax and carbon fabrics. Further remarkable results showed that the same specimen provided the highest values of the supported maximum load after the surface treatment. Influence of the PEI treatment on the strength values with regard to the stacking sequence and polyelectrolyte concentration led to controversial results. Decrease of flexural modulus after the surface treatment was observed in the case of all samples.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.