Polycrystalline Ho: LuAG laser ceramics: Fabrication, microstructure, and optical characterization

Abstract

AbstractHo:Lu3Al5O12(LuAG) transparent ceramics are potential 2 μm eye‐safe laser materials. Polycrystalline 0.8 at.% Ho:LuAG ceramics with high optical quality were successfully fabricated by solid‐state reactive sintering of high‐purity oxide powders. The microstructure, the optical transmission, the spectrum characteristic, and the laser performance were investigated in this paper. The average grain size of Ho:LuAG ceramics vacuum sintered at 1830°C for 30 hour is about 14 μm. The in‐line transmittance of the sample is measured to be 81.7% and 82.0% at 1000 and 2250 nm, respectively. The absorption and the emission cross sections are calculated to be 0.88 × 10−20 cm2 at 1906 nm and 1.26 × 10−20 cm2 at 2094 nm. Using a thulium‐doped yttrium‐lithium‐fluoride (Tm:YLF) laser with the central wavelength of 1907.5 nm as the pump source, 2.67 W continuous wave (CW) laser operation at 2100.74 nm was obtained with a slope efficiency of 26.5%. The beam quality factor M2 was calculated to be 1.1, which indicated nearly diffraction‐limited beam propagation and the laser was the fundamental TEM00 Gaussian mode.