Abstract
The paper describes design of a high-speed polarization monitor system. Describe of hardware design including implementation of FPGA bitstream to the acquisition card and also is presented the graphical user interface (GUI) for processing the measured data. The system is based on Lightwaves2000 Prime controller and a MyRIO device is used for data acquisition. The system is capable sending data from four photodiodes to graphical user interface using the TCP protocol with a sampling frequency of up to 6.5 kS/s. The GUI enables graphical representation of Stokes parameters and also can setup the device parameters. System enables detection of events to an optical fiber caused by changes in ambient conditions using state of polarization (SOP) changes analysis.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Advances in Telecommunications, Electrotechnics, Signals and Systems
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
