Polarization Characterization of LEDs by Stokes Parameters Measurements

Abstract

Stokes parameters have been measured by using a polarimeter consisting of a rotating phase plate before a fixed polarizer for bullet-shaped red, green and blue LEDs at 3 different directions of 0°, 45° and 90° from the principal axis. The degree of polarization is minimum at the observation angle 0° (observed head-on) for all colors as expected but has non-zero values (1-9%). As for the possible cause for the partial polarization, it is likely to be brought by striae inside the transparent epoxy resin that can be easily visible. Data at observation angle 90° have features common for all colors; the degree of polarization is highest, the long axis azimuth of the polarization ellipse is nearly in the horizontal direction, and the ellipticity is small. These features can be explained as follows. At observation angle 90°, only small fraction of the beam emitted nearly horizontally is detected possibly through multireflection (the plane of incidence is in the vertical plane) inside the top- and bottom-surfaces (in the horizontal direction) of the chip substrate. Since the reflectance for s-polarization (horizontal component) is higher than that for p-polarization, the emerging beam becomes horizontally polarized. The hypotheses that geometrical asymmetry generates polarization is experimentally supported.