Abstract
Surface modification of PMMA and FEP polymers using extreme ultraviolet (EUV) in two spectral ranges was investigated. A laser-plasma EUV source based on a double stream gas puff target equipped with an Au coated ellipsoidal collector was used for the experiment. The spectrum of the focused radiation from Kr plasma consisted of a narrow feature with a maximum at 10 nm and a long-wavelength tail up to 70 nm. Al and Zr filters were employed for the selection of radiation from these two spectral regions. The radiation fluences in the two cases were comparable. Polymer samples were mounted in the focal plane of the EUV collector and irradiated for 1–2 min with a 10 Hz repetition rate. Weak ablation accompanied by creation of micro- and nanostructures of different kinds was obtained in both cases. Significant differences in the surface structures after irradiation of PMMA and FEP in these two spectral regions were revealed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
