Platinum Nanosheets Intercalated into Natural and Artificial Graphite Powders.

Abstract

Insertion of sheet-type platinum particles (platinum nanosheets) between graphite layers was achieved by a thermal treatment of a mixture of platinum chloride (IV) and graphite powder (natural graphite or artificial graphite) under 0.3 MPa of chlorine at 723 K, followed by the treatment under 40 kPa of hydrogen pressure. Similar platinum nanosheets, which were 1-3 nm in thickness and 100-500 nm in width and had a number of hexagonal holes and edges with 120° angle, were formed between the layers of both natural graphite or artificial graphite; however, their location in the graphite layers depended on the type of graphite used. A number of platinum nanosheets were observed in the edge region of natural graphite particles which have flat surface. On the other hand, a number of platinum nanosheets were found inside and away from the edge of the artificial graphite particles especially in the vicinity of the cracks. Both the platinum nanosheet-containing artificial and natural graphite samples showed high selectivity to cinnamyl alcohol in cinnamaldehyde hydrogenation under supercritical carbon dioxide conditions, while spherical platinum particles, which were located on the surface of natural and artificial graphite, showed lower selectivity.