Abstract
AbstractThe oxide coating that occurs on platinum electrodes would be expected to influence oxygen diffusion rate (ODR) measurements on the basis of electro‐chemistry literature. However, no consistent influence of condition of electrode oxidation on ODR measurement in clay suspension was found by the authors. The current density on electrodes in clay suspensions was suspected of being below that density where the oxide would exhibit an influence on current.A deposit of salts, principally calcium bicarbonate, and clay particles, principally biotite, on electrodes left in place in a loamy sand reduced measured ODR's by an average of more than 50% after 2 months compared to ODR's from reinserted electrodes in the same soil. The deposits did not form to such an extent on electrodes in a clay and ODR measurements from in‐place electrodes remained comparable to those from reinserted ones throughout the 2‐month period.A nitric acid pretreatment procedure provided an electrode cleaning technique without any abrasion and brought electrodes to an oxidized condition after prolonged use or disuse.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.