Abstract
A low-environmental load surface modification technique for plating the fluorocarbon polymers films is developed using an atmospheric-pressure argon and acrylic acid vapor nonthermal plasma graft polymerization. The results of the T-type peeling test show that the peeling strength of copper plating on the treated PTFE (polytetrafluoroethylene) film is approximately 46 times greater than that on the untreated film. With scanning electron microscope analysis of the surface of the copper plating on the treated PTFE, it is confirmed that the hydrophilic surface of the treated film contributes to uniform copper plating.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.