Abstract
Ultrasonic Lamb wave techniques are widely used in a number of NDE applications. To excite Lamb waves, mode conversion of bulk waves or photo acoustic excitation are often used. Both of these approaches suffer from the need for liquid couplant or ablation of materials to reach good signal to noise ratio. In this paper, we propose a novel technique that utilizes point source excitation and detection of Lamb waves through dry, elastic contacts to monitor velocity changes. We demonstrate the power of this approach in ultrasonic pipe erosion/corrosion monitoring and its potential application in aircraft skin defect imaging. We present results of measurements of plate thickness, and erosion/corrosion in a section of pipe that was removed from service, as well as imaging of defects in an aluminum thin plate.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.