Plasticating Single-Screw Extrusion

Abstract

There are two types of extruder: (1) single-screw extruders and (2) twin-screw extruders. The single-screw extruder is one of the most important pieces of equipment in the processing of thermoplastic polymers. Accordingly, during the past three decades, many attempts have been made to analyze the performance of single-screw extruders using different degrees of mathematical sophistication (Cox and Fenner 1980; Donovan 1971; Edmondson and Fenner 1975; Elbirli et al. 1983, 1984; Halmos et al. 1978; Han et al. 1991a, 1991b, 1996; Lee and Han 1990; Lindt 1976; Lindt and Elbirli 1985; Shapiro et al. 1976; Tadmor 1966; Tadmor and Klein 1970; Tadmor et al. 1967). There are two types of single-screw extruders: (a) plasticating and (b) melt-conveying. The plasticating single-screw extruder conveys a solid polymer from the feed section to the melting section, where most of the melting (or softening) occurs, and then transports the melted or softened polymer to a shaping device (e.g., dies and molds). The meltconveying extruder does not include a melting section; it simply transports an already softened polymer to a shaping device (e.g., rubber extruder). Single-screw extruders are used for various purposes, such as melting and pumping, compounding with an additive(s) or filler, cooling and mixing, removing residual monomers or solvents in polymer (i.e., polymer devolatilization), and cross-linking reactions. Single-screw extruders are simple to operate and relatively inexpensive as compared with twin-screw extruders. However, there are situations where a single-screw extruder cannot function as effectively as a twin-screw extruder. In the design of plasticating single-screw extruders, one needs information on (1) the physical and thermal properties of polymers (e.g., friction coefficient between the solid polymer and barrel wall, thermal conductivity of polymer, specific heat as a function of temperature, melting point of polymer, and heat of fusion of polymer) and (2) rheological properties of polymers as functions of shear rate and temperature. Due to the complexity involved in the design of extruders, it is highly desirable for one to establish relationships between material variables and processing variables.