Abstract
Plastic flow behavior and microstructure evolution during hot working and heat treatment of Ti-6Al-4V synthesized via a laser-deposition, Laser Engineered Net Shaping (LENSℳ), process were established. To this end, isothermal, hot compression tests were conducted on samples in either a deposited + stress relieved condition or a deposited + hot isostatically pressed (hipped) condition. The starting microstructures consisted of columnar grains with fine or coarse Widmanstatten (basketweave) alpha platelets. At subtransus temperatures, the flow curves of both microstructural conditions exhibited a peak stress at low strains followed by extensive flow softening; these curves were almost identical to previous measurements on ingot-metallurgy (IM) Ti-6Al-4V with similar transformed microstructures. In addition, the kinetics of globularization of the alpha phase during subtransus deformation or subsequent static heat treatment were found to be the same as for IM Ti-6Al-4V with comparable alpha-platelet thicknesses. During supertransus heat treatment, moderately fine beta-grain microstructures were developed in samples that had been predeformed below the beta transus. Such a heat treatment for samples previously deformed above the transus gave rise to a nonuniform distribution of coarse beta grains, an effect attributed to critical grain growth.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
