Plasma treatment of dentin surfaces for improving self-etching adhesive/dentin interface bonding

Abstract

This study is to evaluate plasma treatment effects on dentin surfaces for improving self-etching adhesive and dentin interface bonding. Extracted unerupted human third molars were used after crown removal to expose dentin. One half of each dentin surface was treated with atmospheric non-thermal argon plasmas, while another half was untreated and used as the same tooth control. Self-etching adhesive and universal resin composite was applied to the dentin surfaces as directed. After restoration, the adhesive–dentin bonding strength was evaluated by micro-tensile bonding strength (μTBS) test. Bonding strength data was analyzed using histograms and Welch׳s t-test based on unequal variances. μTBS test results showed that, with plasma treatment, the average μTBS value increased to 69.7±11.5MPa as compared with the 57.1±17.5MPa obtained from the untreated controls. After 2 months immersion of the restored teeth in 37°C phosphate buffered saline (PBS), the adhesive–dentin bonding strengths of the plasma-treated specimens slightly decreased from 69.7±11.5MPa to 63.9±14.4MPa, while the strengths of the untreated specimens reduced from 57.1±17.5MPa to 48.9±14.6MPa. Water contact angle measurement and scanning electron microscopy (SEM) examination verified that plasma treatment followed by water rewetting could partially open dentin tubules, which could enhance adhesive penetration to form thicker hybrid layer and longer resin tags and consequently improve the adhesive/dentin interface quality.