Plasma Enhanced Atomic Layer Deposition of Silicon Nitride for Two Different Aminosilane Precursors Using Very High Frequency (162 MHz) Plasma Source.

Abstract

Plasma enhanced atomic layer deposition (PEALD) of silicon nitride (SiNx) using very high frequency (VHF, 162 MHz) plasma source was investigated at the process temperatures of 100, 200, and 300 °C. Two aminosilane precursors having different numbers of amino ligands, bis(tert-butylamino)silane (BTBAS) and di(sec-butylamino)silane (DSBAS), were used as Si precursors. A comparative study was also conducted to verify the effect of the number of amino ligands on the properties of SiNx film. At all process temperatures, DSBAS, having one amino ligand, performed better than BTBAS in various aspects. SiNx films deposited using DSBAS had lower surface roughness, higher film density, lower wet etch rate, improved electrical characteristics, and higher growth rate than those deposited using BTBAS. With the combination of a VHF plasma source and DSBAS with one amino ligand, the SiNx films grown at 300 °C exhibited low wet etch rates (≤2 nm/min) in a dilute HF solution (100:1 of deionized water:HF) as well as low C content below the XPS detection limit. Also, excellent step coverage close to 100% on high aspect ratio (30:1) trench structures was obtained by using VHF plasma, which could provide sufficient flux of plasma species inside the trenches in conjunction with DSBAS having fewer amino ligands than BTBAS.