Plasma assisted parts' manufacturing: sintering and surface texturing - part II - influence of inter-cathode distance and gas pressure

Abstract

The acquirements and potentiality universe of cleaning, heating and/or sputtering effects caused by plasma species bombardment phenomenon on the surface characteristics and finishing of manufactured parts treated in DC abnormal glow discharge opens a new research and development field, called here of Plasma Assisted Parts' Manufacturing (PAP'M). The adequate control of the sputtering mechanism allows the obtainment of different kinds of surface. Therefore, the design of rough or smooth surface, presenting a modified distribution of surface porosity and texturing could be idealized, in accordance with the desired surface characteristics, as the parts are simultaneously sintered and treated. This is the second part (out of two) of the work performed in hollow cathode discharge (HCD) and it presents the first results of the surface morphology's changes in the pressed iron samples and in the internal surface of the external cathode as a function of the inter-cathode distance and gas pressure. Potential applications include small diameters' cylindrical parts and components like axles, pins, pivots, and tubes and pipes presenting small internal diameters. Sputtering effects were quantified by means of mass loss, and Ra and Rz roughness measurements and qualified by means of SEM. Results indicate the sputtering mechanism is highly dependent of the hollow cathode effect, in HCD sintering and surface texturing treatments, comprising an important contribution to the development of green technologies for surface texturing, surface engineering, and part's manufacturing.