Planting materials for warm tropic potato production: growth and yield of transplanted seedlings or rooted cuttings and tuber materials in the field

Abstract

Expansion of potato production in lowland tropical regions has been constrained by the lack of planting materials, given that adapted genotypes and suitable field management practices now exist. The respective performance of transplanted materials (i.e., true potato seed (TPS) seedlings or rooted stem cuttings) produced in situ in the warm tropics were compared with that of genetically identical seedling tubers (tubers produced from seedlings) or seed tubers. Seed and seedling tubers had been previously produced under optimal cool conditions. Transplanted materials achieved lower maximum leaf area index than did tuber materials (1.3–2.2 vs. 2.7) but relative growth rates of cuttings and seedlings were greater. This was in part due to the greater net assimilation rate of cuttings and to greater leaf:stem ratio for both compared with plants originating from tubers. Stolon and tuber formation were greater in seed tubers than in cuttings and in seedlings versus seedling tubers. On average, seedlings produced 14 tubers per plant, apical cuttings 12, seedling tubers 8, and stem cuttings 6. Tuber yields within a genotype were statistically similar for crops from seed tubers or cuttings and for crops from seedling tubers or seedlings. However, the proportion of marketable (i.e., > 3.5 cm diameter) tubers was approximately 12% less in the crops from seed tuber and seedlings compared with those from cuttings and seedling tubers, respectively. Within a genotype, the crop duration in the field was similar whatever the type of planting material. Maximum yields, at 23 t/ha in warm sites, were still below those of temperate potato crops, but could be achieved equally well with transplanted in situ-produced materials or imported cool-climate seed tubers.