Abstract

This work describes the principle of operation, assembly and performance of one branch of the 44 GHz back end module (BEM) for the Planck low frequency instrument (LFI). This subsystem constitutes a fully representative branch of the qualification-model version (QM). It includes waveguide to microstrip transition, GaAs pseudomorphic high electron mobility transistor (PHEMT) low noise amplifiers (LNA), bandpass filter, square-law detector and dc amplifier. The fundamentals of the design of the RF part are described and all of the components have been tested individually before integration. Using single tone and wideband noise stimuli, the output voltage has been measured for several input powers, in order to obtain the sensitivity factor of the complete BEM. The effective bandwidth and the equivalent noise temperature have been calculated from the measurements, taking into account the frequency dependence on the noise source and the BEM. Finally, the low frequency output power spectrum has been obtained and a maximum 1/f knee frequency around 200 Hz has been measured with a 3 dB output signal video bandwidth above 50 KHz.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.