Planar Perovskite Solar Cells with High Efficiency and Fill Factor Obtained Using Two-Step Growth Process.

Abstract

Hybrid organic-inorganic perovskite solar cells (PSCs) have been regarded as the most promising next-generation photovoltaics (PVs) because of their potential for low-cost fabrication and advances in their development. Superior quality of the photoactive perovskite layer is a main factor for further increasing the PV performance of the organic-inorganic perovskite solar cells (PSCs). Herein, we successfully obtained perovskite with a high crystallinity and large grain size by utilizing excess PbI2 and SSGP technique and demonstrated a superior PV performance of normal-architecture planar PSCs. The SSGP PSCs with the highest fill factor (FF) reported thus far (83.4%) to our knowledge were obtained without sacrificing other PV parameters. Moreover, a high efficiency of 21.3% (21.6%) with a high FF of 80.0% (81.2%) in forward (reverse) scan was achieved. The unencapsulated SSGP PSCs showed robust continuous light-soaking and thermal stability under harsh characterization conditions. Additionally, we achieved a high efficiency of 20.1% with a negligible hysteresis on the large active area SSGP PSCs (∼1 cm2). The optical properties, efficient carrier extraction, and reduction of recombination loss of the SSGP perovskite significantly contribute to the high PV performance and robust stability of SSGP PSCs.