Abstract
Sintered small-module gears have two important aspects that readily follow from the name: they are sintered and with a small module of 1.5875 mm (DP 16). Both aspects are to date insufficiently described for gear designers despite an increased need for sintered small-module gears. This article reviews a decade of systematic experimental investigations with regard to pitting resistance of sintered small-module gears. Pitting resistance levels are listed for the common pressing/sintering/surface densification technologies of today. Currently the highest pitting resistance of 1300 MPa is achieved for pressed, sintered, rolled, re-sintered and case carburized low-alloy gears in comparison with 1800 MPa for the reference ground case-carburized 16MnCr5-wrought gears. This offset can, however, be compensated by selection of a relatively higher viscosity and lower operating temperature of the lubricating oil, if the application allows it. Thus, powder metal technology can once again contribute to a competitive total cost with high material utilization.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Proceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
