Abstract
General testing procedures which will ascertain whether a Doppler ultrasonic blood flowmeter is correctly designed and operating properly are presented. A commercial Doppler ultrasonic blood flowmeter using the procedure is evaluated. Two pitfalls were encountered which prevented its proper operation. High-frequency response was inadequate, which introduced a nonlinearity into the input-output calibration curve. Low-frequency gain was too high, resulting in wall-motion artifacts. These problem areas are described in detail, and a remedy for each is suggested.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
